Make A Tool-Post To Hold The 32mm Part-Off Blades On The Myford

12,362 views

About this video

Hand-picked by a BrighterTube curator · found via Reddit r/Machinists thread: Any good YouTube channels that demonstrate useful machining techniques that aren't tool companies showing off what their $1000 bit can do in their $1.5m 8 axis machine? · 82% confidence

Demonstrates making a tool-post to hold 32mm part-off blades on Myford, teaching accessory fabrication and setup. Shows practical modification for lathe tooling.

A 17-minute video from Steve Jordan: “Make A Tool-Post To Hold The 32mm Part-Off Blades On The Myford”.

Video by Steve Jordan, played through YouTube's embedded player.