Back plate for 6 jaws chuck part 6

2,079 views

About this video

Hand-picked by a BrighterTube curator · found via Reddit r/Machinists thread: Any good YouTube channels that demonstrate useful machining techniques that aren't tool companies showing off what their $1000 bit can do in their $1.5m 8 axis machine? · 82% confidence

Demonstrates the fabrication and installation of a back plate for a 6-jaw chuck, showing machining techniques and assembly methods. Part 6 of a multi-part series on this specific project with technical detail typical of approved uploads.

A 33-minute video from Pierre's Garage: “Back plate for 6 jaws chuck part 6”.

Video by Pierre's Garage, played through YouTube's embedded player.

Part of Back plate for 6 jaws chuck