11:5810 tips for writing a clear state machine in Verilog: A UART transmitter example.
A 12-minute video from FPGAs for Beginners: “10 tips for writing a clear state machine in Verilog: A UART transmitter example.”.
16.9K subscribers on YouTube
Shorts, livestreams, trailers and promos are never listed. Unless a curator approved this channel in full, only individually picked videos appear.
11:58A 12-minute video from FPGAs for Beginners: “10 tips for writing a clear state machine in Verilog: A UART transmitter example.”.
4:23A 4-minute video from FPGAs for Beginners: “6 Do's and don'ts for good Verilog coding practices”.
20:24A 20-minute video from FPGAs for Beginners: “A quick and easy Ethernet Frame state machine, explained from start to finish!”.
17:40Intro
A 18-minute video from FPGAs for Beginners: “AXI Introduction Part 1: How AXI works and AXI-Lite transaction example”.
8:46A 9-minute video from FPGAs for Beginners: “AXI Introduction Part 2: AXI-Lite state machine example explained!”.
3:12A 3-minute video from FPGAs for Beginners: “AXI Part 3: AXI-Lite testbench (briefly)”.
12:11Intro
A 12-minute video from FPGAs for Beginners: “AXI Stream basics for beginners! A Stream FIFO example in Verilog.”.
23:04A 23-minute video from FPGAs for Beginners: “AXI-Stream Arbiter example”.
7:19A 7-minute video from FPGAs for Beginners: “Algorithm preparation for the FPGA: A polynomial window example”.
6:17A 6-minute video from FPGAs for Beginners: “Creating input and output delay constraints”.
11:19A 11-minute video from FPGAs for Beginners: “FPGA Audio to my PC over Ethernet! PDM Microphone and CIC filter explained!”.
8:51Intro
A 9-minute video from FPGAs for Beginners: “FPGA Clock and timing concepts explained simply for beginners using two analogies!”.
13:53A 14-minute video from FPGAs for Beginners: “Fixed point basics in Verilog for Beginners! Continuation of polynomial example.”.
9:32A 10-minute video from FPGAs for Beginners: “Fixing failed timing, a practical example in verilog!”.
13:48A 14-minute video from FPGAs for Beginners: “Flashing a LED with Vivado and a Nexys A7 FPGA board: Step by step walkthrough!”.
7:52A 8-minute video from FPGAs for Beginners: “Generate statement and for loop example in Verilog: A byte-swap in three ways.”.
9:30A 10-minute video from FPGAs for Beginners: “Handling Ethernet FIFO overflows in SystemVerilog! How to keep packets intact above line rate!”.
9:08Intro
A 9-minute video from FPGAs for Beginners: “How do I write to file? Testbench basics for beginners in Verilog!”.
11:21Intro
A 11-minute video from FPGAs for Beginners: “How much combinitorial logic is too much? Always block guide for beginners by FPGA professional.”.
6:01A 6-minute video from FPGAs for Beginners: “ILA in a Zynq: View signals in hardware!”.
29:28Intro
A 29-minute video from FPGAs for Beginners: “My favourite state machine, always blocks: one or many? and simplifying your SystemVerilog Style!”.
16:11A 16-minute video from FPGAs for Beginners: “Polynomial example part 2! Final window code with pipelining!”.
19:24A 19-minute video from FPGAs for Beginners: “Reading from and writing to file: My PDM testbench from start to finish.”.
5:45A 6-minute video from FPGAs for Beginners: “Setting up a Nexys board in Linux!”.
29:23Intro
A 29-minute video from FPGAs for Beginners: “The Critical FPGA Basics: Always blocks, Inferred latches, and why the FPGA needs a clock, anyway?!”.
7:29A 7-minute video from FPGAs for Beginners: “Timing Constraints: How do I connect my top level source signals to pins on my FPGA?”.
8:40A 9-minute video from FPGAs for Beginners: “Timing report and RTL schematic interpretation”.
20:12A 20-minute video from FPGAs for Beginners: “Tips for Verilog beginners from a Professional FPGA Engineer”.
10:15A 10-minute video from FPGAs for Beginners: “Vivado IP generator tricks: Generating IP, saving to version control, and generating example code!”.
4:30A 4-minute video from FPGAs for Beginners: “What percentage of my always blocks are synchronous?”.
5:45A 6-minute video from FPGAs for Beginners: “When and how to use the Multiplier IP core”.
20:00Intro
A 20-minute video from FPGAs for Beginners: “Zynq Part 1: Vivado block diagram (no Verilog/VHDL necessary!)”.
20:53A 21-minute video from FPGAs for Beginners: “Zynq Part 2: Zynq Vitis Example with PL Fabric GPIO and BRAM”.
16:12A 16-minute video from FPGAs for Beginners: “Zynq Part 3: Combining my own HDL with the Vivado block diagram!”.